Support Projectors PowerLite Series Epson PowerLite 935W

When and how should I clean or replace the air filter?

  • Clean the projector's air filter or vents if they get dusty, or if you see a message telling you to clean them.
    1. Turn off the projector and unplug the power cord.
    2. Gently remove the dust using a small vacuum designed for computers or a very soft brush (such as a paintbrush).

      Note: You can remove the air filter so you can clean both sides of it. Do not rinse the air filter in water, or use any detergent or solvent to clean it.

      Caution:
      Do not use canned air. The gases may leave a residue or push dust and debris into the projector's optics or other sensitive areas.

    3. If dust is difficult to remove or the air filter is damaged, replace the air filter.

    Replacing the Air Filter

    You need to replace the air filter in the following situations:
    • After cleaning the air filter, you see a message telling you to clean or replace it
    • The air filter is torn or damaged

    You can replace the air filter while the projector is mounted to the ceiling, if necessary. The illustrations here show the projector placed on a table.

    1. Turn off the projector and unplug the power cord.
    2. Slide the air filter cover latch and open the air filter cover.
    3. Pull the air filter out of the projector.

      Note: Air filters contain polyphenylene ether, polystyrene resin, and polypropylene. Dispose of used air filters according to local regulations.

    4. Place the new air filter in the projector as shown and push gently until it clicks into place.
    5. Close the air filter cover.
Published:  14-May-2013 Was this helpful? Thank you for the feedback!
Was this helpful?
Please tell us why this was not helpful.