When and how should I clean or replace the air filter?
-
See below.
Cleaning the Air Filter and Vents
Clean the projector's air filter or vents if they get dusty, or if you see a message telling you to clean them.- Turn off the projector and unplug the power cord.
- Gently remove the dust using a small vacuum designed for computers or a very soft brush (such as a paintbrush).
- If dust is difficult to remove or the air filter is damaged, replace the air filter.
Replacing the Air Filter
You need to replace the air filter in the following situations:- After cleaning the air filter, you see a message telling you to clean or replace it
- The air filter is torn or damaged
You can replace the air filter while the projector is mounted to the ceiling or placed on a table.
- Turn off the projector and unplug the power cord.
- Carefully open the air filter cover.
- Pull the air filter out of the projector.
Note: Air filters contain ABS resin and polyurethane foam. Dispose of used air filters according to local regulations.
- Place the new air filter in the projector as shown and push gently until it clicks into place.
- Close the air filter cover.
Optional Equipment and Replacement Parts
Published: 17-Aug-2017
Was this helpful? Thank you for the feedback!