text.skipToContent text.skipToNavigation

How do I connect my product with a Wi-Fi Direct connection?

    See below.

    Enabling Wi-Fi Direct Mode

    You can enable Wi-Fi Direct mode to allow direct communication between your product and computer or other devices without a wireless router or access point.
    1. Press the   home button, if necessary.
    2. Press the left or right arrow button to select Wi-Fi Setup and press the OK button. You see this screen:
       
    3. Press the up or down arrow button to select Wi-Fi Direct and press the OK button. You see this screen:
       
    4. Press the OK button. You see this screen:
       
    5. Press the OK button.
    6. Press the down arrow button, then press the OK button to change the Wi-Fi Direct password.

      Note: If you have already connected devices or computers to your product via Wi-Fi Direct, they will be disconnected when you change the password.

    7. Enter your Wi-Fi Direct password.

      Note: Your password must be at least 8 and no more than 22 characters long.


       
      • Press the arrow buttons to highlight a character or a function button displayed on the keypad. Then press the OK button to select it.
      • To change the case of letters or select symbols, select AB12 (uppercase), ab12 (lowercase), or Symbol and press the OK button. Then highlight a number or symbol and press the OK button to select it.
      • To enter a space, select Space and press the OK button.
      • To delete characters, select the back arrow and press the OK button.
      • When you finish entering characters, select Done and press the OK button.
    8. Press the OK button. You see this screen:
       
    9. Use your computer or wireless device to select the Wi-Fi network name (SSID) displayed on the LCD screen, then enter the password shown.
    10. Press the OK button to exit. You see either an AP or Direct connection symbol on the LCD screen and should be able to connect to your product directly from your computer or device, and then print. If you are printing from a computer, make sure you installed the network software as described on the Start Here sheet.

      Note: Make a note of the SSID and password that appear.

      If the AP or Direct connection symbol is not displayed on the LCD screen, Wi-Fi Direct mode is not enabled. Repeat these steps to try again.

Published:  16-Jan-2017 Was this helpful​? Thank you for the feedback!
Please tell us why this was not helpful.​
Please enter a valid email address