Support Scanners DS Series Epson WorkForce DS-510

How should I clean the inside of the product?

  • Clean your scanner regularly to make sure that no dust builds up on the glass scanning surfaces. Dust can cause spots or lines in your scanned images.

    Do not use a hard brush, alcohol, or paint thinner to clean the product or you may damage it. Do not use oil or other lubricants inside the product or let water get inside it.

    1. Press the  power button to turn off the scanner.
    2. Unplug the AC adapter.
    3. Disconnect any connected cables.
    4. Pull down on the cover open lever and open the scanner cover.
    5. Use a soft, dry cloth to wipe off any stains on the rollers inside the scanner cover.
    6. Wipe off any stains on the pickup rollers.
    7. Plug in the AC adapter and press the  power button to turn on the scanner.
    8. Wipe off any stains on the remaining four rollers.
    9. Hold down the  start button for at least two seconds, then press the  start button several times to rotate the rollers. Continue to wipe off any stains on the rollers.
    10. Press the  power button to turn off the scanner.
    11. Unplug the AC adapter.

      Note: Wipe off any stains on the glass scanning surfaces using a soft, dry cloth. If the glass surface is stained with grease or some other hard-to-remove material, use a small amount of glass cleaner on a soft cloth to remove it. Wipe off all remaining liquid.

      Do not spray glass cleaner directly on the scanning surfaces. Be careful not to place too much force on the glass.

    12. Plug in the AC adapter.
    13. Close the scanner cover.

Published:  5-Feb-2014 Was this helpful? Thank you for the feedback!
Was this helpful?
Please tell us why this was not helpful.