How do I connect my WPS-enabled wireless router to my product?

• If you have a WPS-enabled wireless router, you can use Wi-Fi Protected Setup (WPS) to connect your scanner to the network.
  1. Make sure the scanner is turned off.
  2. Set the connection mode switch on the scanner to the Wi-Fi position.
     
  3. Enable WPS on your router by pressing the WPS button or enabling the WPS setting in your router firmware. The router enters WPS discovery mode for 2 minutes.
  4. Turn on the scanner.
  5. Press and hold the Connect button on the scanner for at least 3 seconds, then release it when the ready and  Wi-Fi lights flash alternately.
     
     

     Note: If you do not complete this step within 2 minutes, repeat steps 1 to 5.

     When the ready and  Wi-Fi lights on the scanner stay on, the scanner is connected to the network.
  6. Select the link below to set up network scanning. You must set up network scanning to connect your computer and wireless scanner.
  Related tasks
  Setting Up Network Scanning