How do I replace the product rollers?
-
Replace the scanner rollers when the number of scans exceeds the life cycle of the rollers. Check the scanner roller counter to see when you need to replace the rollers.
- Turn off the scanner.
- Unplug the AC adapter.
- Disconnect any connected cables.
- Pull down on the cover open lever and open the scanner cover.
- Press down on the pickup roller cover latch and pull up the cover to remove it.
- Pull down the tab on the pickup rollers and slide the rollers to the right to remove them.
- To install the new pickup rollers, align the notches on the roller unit and slide it to the left. Press up on the tab to secure the rollers.
- Align the bottom edge of the pickup roller cover into the notches as shown and press it down until it clicks into place.
Note: If you are not able to close the cover, the pickup rollersare not installed correctly. Remove the roller unit and reinstall it, then try to close the cover again.
- Squeeze the tabs on the sides of the separation roller cover and open the cover.
Caution:
Be careful not to apply too much force when opening the cover.
- Slide the separation roller to the left and remove it.
- To install a new separation roller, insert the end of the roller into the hole on the right side and lower the other end of the roller into place.
- Close the separation roller cover until you hear it click into place.
Note: If you are not able to close the cover, the roller is not installed correctly. Remove the roller and reinstall it, then try to close the cover again.
- Close the scanner cover.
- Plug in the AC adapter and turn on the scanner.
- Reset the roller counter after replacing the rollers.
Checking the Scanner Roller Counter
Resetting the Scanner Roller Counter
Related references
User Replaceable Epson Scanner Parts and Accessories
Published: 13-Jul-2017
Was this helpful? Thank you for the feedback!