What settings do the DIP switches control?

• The LQ-510 and AP-4000 have two 8-position DIP switches. These switches are located at the panel of the printer under a small access door.
  
  

  Country	SW 1-1	SW 1-2	SW 1-3
  USA	ON	ON	ON
  France	ON	ON	OFF
  Germany	ON	OFF	ON
  United Kingdom	ON	OFF	OFF
  Denmark 1	OFF	ON	ON
  Sweden	OFF	ON	OFF
  Italy	OFF	OFF	ON
  Spain 1	OFF	OFF	OFF

  
  

  Font	SW 1-4	SW 1-5
  Roman	OFF	OFF
  San Serif	ON	OFF
  Slot	OFF	ON
  Draft	ON	ON

  
  

  Switch	ON	OFF
  SW 1-6	Condensed	Normal
  SW 1-7	Graphic Characters	Italic Characters
  SW 1-8	CSF Enabled	CSF Disabled
  SW 2-1	12" Page Length	11" Page Length
  SW 2-2	Tear Off Mode On	Tear Off Mode Off
  SW 2-3	1" Skip over Perf	Skip over perf Inactive
  SW 2-4	CR Produces CR + LF	CR Only
  SW 2-5	8K Input Buffer User-Defined Characters Disabled	1K Input Buffer User-Defined Characters Disabled
  SW 2-6	Bidirectional Graphics	Unidirectional Graphics

  
  

  Character Pitch	SW 2-7	SW 2-8
  10 Pitch	OFF	OFF
  12 Pitch	ON	OFF
  15 Pitch	OFF	ON
  Proportional	ON	ON

  
  Note: Unidirectional graphics is the printer default. Placing switch 2-6 in the ON position allows selection of Bidirectional graphics after an ESC U O is sent.