I see the message Installation Failed when I install my product's wireless network software. What should I do?

  • Check the following:
    • Make sure that your wireless router or access point is set to use one of the supported security settings: None, WEP 64, WEP 128, or WPA-PSK (TKIP/AES) WPA2 compliant.
    • If security is enabled for your wireless router or access point, make sure that you entered the correct security key or passphrase.
    • If there are any access restrictions (such as MAC address filtering) set on the wireless router or access point, register the printer's MAC address on the router or access point. Print a Network Status Sheet to obtain the MAC address. Then see your router or access point's documentation for instructions.
    • Disable any settings (such as AP Isolation, Client Isolation, or Privacy Separator) on your wireless router or access point that would prevent wireless devices from communicating with each other.
Published:  27-Oct-2011 Was this helpful​? Thank you for the feedback!
Please tell us why this was not helpful.​
Please enter a valid email address