How should I load envelopes?
-
Do the following:
Loading Paper in the Sheet Feeder
You can print documents and photos on a variety of paper types and sizes.- Flip the feeder guard forward, then raise the paper support and its extension.
- Pull out the output tray and open the paper stopper on the end.
Note: If you print on legal-size or longer paper, leave the paper stopper closed.
- Slide the edge guide to the left.
- If you are inserting a stack of paper, fan the sheets first and tap the stack on a flat surface to even the edges.
Note: Do not fan or curl photo paper.
- Do one of the following:
- Insert paper, glossy or printable side up and short edge first, against the right side and beneath the line on the left edge guide.
- Load up to 10 envelopes against the right side. Load them printable side up and flap edge left.
- Load a sheet of loose-leaf or other paper with holes facing as shown.
- Insert paper, glossy or printable side up and short edge first, against the right side and beneath the line on the left edge guide.
- Slide the edge guide against the paper, but not too tightly. Then, flip the feeder guard back.
- If prompted by the product's LCD screen, select the size and type of the paper you loaded and press the OK button.
- Load only the recommended number of sheets.
- Load paper short edge first, no matter which way your document faces.
- Load letterhead or pre-printed paper top edge first.
- Do not load paper above the arrow mark inside the edge guide.
- If you have trouble loading a stack of envelopes, press each envelope flat before loading it or load one envelope at a time.
- Do not load envelopes that are curled, folded, or too thin, or that have plastic windows.
- Check the paper package for any additional loading instructions.
- If you use paper with binder holes, load only one sheet at a time and use only these sizes: Letter (8.5 × 11 inches [216 × 279 mm]), A4 (8.3 × 11.7 inches [210 × 297 mm]), or Legal (8.5 × 14 inches [216 × 356 mm]).
Paper Loading Capacity
Paper Specifications - Flip the feeder guard forward, then raise the paper support and its extension.
Published: 6-Aug-2015
Was this helpful? Thank you for the feedback!