Support Wearables ProSense Epson ProSense 367

Can the product measure indoor activity?

  • Yes, it measures your indoor activity when you select one of the following workout modes:

    Treadmill

    Pool Swim

    Indoor Bike

    Indoor Run

    Other 2

    To set your product to one of these modes, press down on the Time screen until you see the mode and press Start/Stop. Then press Start/Stop again to start workout measurement.

    Note: Not all of the workout modes listed above may be available when you press down on the Time screen. Use the Epson View app to change which workout modes appear and the order in which they appear.

    Note: GPS positioning is disabled when you set the product to one of the modes listed above. The product uses the built-in stride sensor instead to record measurements, but the product does not record some measurements that require GPS signals, such as your workout route.

    To ensure that your measurements are as accurate as possible, do one of the following before you use the product indoors:

    • If there are no obstacles overhead that could block GPS signals, run or walk outside for approximately 10 minutes while the product is on and GPS positioning is active.
    • If there are obstacles overhead, such as tall buildings or trees, run or walk outside for approximately 30 minutes while the product is on and GPS positioning is active.
Published:  30-Aug-2017 Was this helpful? Thank you for the feedback!
Was this helpful?
Please tell us why this was not helpful.