I see the message No Signal. What should I do?
-
Try the following:
- Press one of the Source buttons on the remote control, or press the
source button on the projector, to select the correct input source. Allow a few seconds for the projector to sync up after pressing the button.
- Press the Blank button on the remote control to make sure the picture hasn't been turned off temporarily.
- Check that the
power light is on, the
power light is not flashing, and the lens cover is off.
- The projector may be in sleep mode. If the
power light is on and the
source light is off, press the
power button to turn the projector back on.
- Make sure your video equipment is turned on.
- Make sure your cable(s) are connected correctly. See Connecting Video and Computer Equipment.
- Press one of the Source buttons on the remote control, or press the
Published: 10-Nov-2010
Was this helpful? Thank you for the feedback!