There is no sound. What should I do?
- Adjust the projector's volume settings.
- Press the A/V Mute or Mute button on the remote control to resume video and audio if they were temporarily stopped.
- Press the Source button on the projector or a source button on the remote control to switch to the correct input source, if necessary.
- Check your computer or video source to make sure the volume is turned up and the audio output is set for the correct source.
- Check the audio cable connections between the projector and your video source.
- If you do not hear sound from an HDMI source, set the connected device to PCM output.
- Make sure any connected audio cables are labeled "No Resistance".
- If you connected an audio device to the projector's Audio Out port, the internal speaker is disabled. However, you can still control the volume level via the remote control.
- If you turn the projector on immediately after turning it off, the cooling fans may run at high speed momentarily and cause an unexpected noise. This is normal.
If there is no sound when you expect it or the volume is too low or high, try the following solutions:
Controlling the Volume with the Volume Buttons
Published: 24-Aug-2017 Was this helpful? Thank you for the feedback!