Support Projectors Q Series Epson EH-QL7000W

When and how should I clean or replace the air filter?

  • See below.

    Cleaning the Air Filter and Vents

    Clean the projector's air filter or vents if they get dusty, or if you see a message telling you to clean them. It is recommended that you clean these parts every 20000 hours, or more often if you use the projector in an environment that is dustier than expected.

    CAUTION:
    Do not use water or detergent to clean the air filter. Do not use canned air, or the gases may leave a flammable residue.

    1. Turn off the projector and unplug the power cord.

      Note: Make sure to remove the vanity board from the projector in advance.

    2. Gently remove the dust using a small vacuum designed for computers or a very soft brush (such as a paintbrush).
    3. Loosen the screws securing the air filter cover and remove the air filter cover (it is attached with a tether).
    4. Pull the air filter out of the projector.
    5. Tap each side of the filter 4 to 5 times to shake off any excess dust. Do this outside the room or away from the projector.

      CAUTION:
      Do not use excessive force when tapping the air filter, or it may crack and become unusable. Do not rinse the air filter in water or use any detergent or solvent to clean it. Do not use canned air; the gases may leave a flammable residue or push dust and debris into the projector's optics or other sensitive areas.

    6. Vacuum the front of the air filter (the side with the tabs) to remove any remaining dust.

      CAUTION:
      Do not rinse the air filter in water, or use any detergent or solvent to clean it. Do not use canned air; the gases may leave a flammable residue, or push dust and debris into the projector's optics or other sensitive areas.

      Note: If dust is difficult to remove or the air filter is damaged, replace the air filter.

    7. Place the air filter back in the projector as shown.
    8. Install the air filter cover as shown.
    9. Tighten the screws.

      Note: After installing the air filter, reinstall the vanity board.

    Replacing the Air Filter

    You need to replace the air filter in the following situations:
    • After cleaning the air filter, you see a message telling you to clean or replace it
    • The air filter is torn or damaged

    You can replace the air filter while the projector is mounted to the ceiling or placed on a table.

    Note: Make sure that the vanity board has been removed from the projector in advance.

    1. Turn off the projector and unplug the power cord.
    2. Loosen the screws and remove the air filter cover as shown (it is attached with a tether).
    3. Pull the air filter out of the projector.

      Note: Air filters contain polypropylene. Dispose of used air filters according to local regulations.

    4. Place the new air filter in the projector as shown.
    5. Attach the air filter cover as shown.
    6. Tighten the screws.

      Note: After installing the air filter, reinstall the vanity board.

Published:  19-Sep-2024 Was this helpful? Thank you for the feedback!
Was this helpful?
Please tell us why this was not helpful.