How do I connect my WPS-enabled wireless router to my product?

• See below.

  Using WPS to Connect to a Network

  If you have a WPS-enabled wireless router, you can use Wi-Fi Protected Setup (WPS) to connect your scanner to the network.
  1. Follow the instructions on the Start Here sheet to install the scanner software on your computer.
  2. Make sure the scanner is turned on.
  3. Set the  Wi-Fi switch to the  Wi-Fi position.
  4. Enable WPS on your router by pressing the WPS button or enabling the WPS setting in your router firmware. The router enters WPS discovery mode for 2 minutes.
  5. Press and hold the  Wi-Fi connect button on the scanner until the ready,  Wi-Fi, and  Wi-Fi AP lights flash alternately.

     Note: If you do not complete this step within 2 minutes, repeat these steps to try again.

     When the ready,  Wi-Fi, and  Wi-Fi AP lights on the scanner stay on, the scanner is connected to the network.

     Note: If the ready light stays on, but the  Wi-Fi and  Wi-Fi AP lights flash simultaneously, connection has failed. Restart the scanner and router, move them closer together, and repeat these steps to try again.