Support Other Products Connectivity Products Epson C823781 (EpsonNet 10/100Base-TX External Print Server)

Why am I getting the message Could not complete communicating configuration data when I send settings to the network adapter?

  • This might happen when using a dial-up router. Run Command Prompt from the computer in which EpsonNet WinAssist is installed, then enter the following command; Format: >ROUTE_ADD_the IP address of the network adapter_ the IP address of the computer (the under bar represents one space) Example: >ROUTE ADD 192.168.192.168 22.33.44.55. Also, reinitialize the network adapter, then try again.
Was this helpful? Thank you for the feedback!
Was this helpful?
Please tell us why this was not helpful.